Before & After Photos

The landing between the house and garage was sinking, creating an unsafe trip hazard for the homeowner. A quick afternoon trip to Kalamazoo by our PolyLEVEL team was all that was needed to raise the concrete slab and make it safe to walk over once again.

James and Joann's home was built in 1999, and within the last few years they've had problems with the concrete in front of their home. Sections of the porch continue to sink despite other companies coming out to fix it. The couple knew Ayers would be up to the challenge, so they called for an inspection. Our crew determined PolyLevel and NexusPro joint sealant would achieve the permanent fix they've been looking for. 

The PolyLevel System is used to repair sinking concrete by drilling minuscule holes into the slab and filling them with foam. The foam raises he slab and fortifies it to make it last even longer. NexusPro is a sealant that fills the cracks in the concrete. It is extremely withstanding to harsh weather so it will remain flexible for yeas, which is important when it comes to Michigan. 

James and Joann were overjoyed that they could finally get this problem taken care of permanently. The couple won't have to deal with the frustration of the porch continuing to sink any longer. 

The sinking stairs made the front of this home unattractive and created a tripping hazard for those walking up. This problem was resolved in less than two hours thanks to PolyLEVEL. With a special mixture of polymers, the concrete step was raised with minimal mess and was able to be walked on in 15 minutes!

Once the snow melted, Bill realized his steps had sunk about 2", making them uneven and unsafe. Luckily our PolyLEVEL injection system is the perfect solution to raise sinking concrete slabs such as steps. It was a one day job and the steps are as good as new!

This customer had a front porch slab that was sinking. The homeowner was looking for a solution that would permanently raise the slab and prevent it from settling again in the future.

The effective PolyLevel system was installed to raise the slab while dealing with the weak soils below that caused it sink in the first place. We drilled a few small holes into the concrete slab, deep enough to reach the soil below. We then injected specialized polymers underneath the concrete that expanded to immediately raise the slabs back to their proper levels. Once installed, the system only needed about 15 minutes to cure and the homeowner was left with the leveled porch he was looking for.